|
not bad for the price. Seem to wear out fairly fast, but compaired to other comparable sanding discs I would say they are acceptable.
Additionally the backing paper is stiff enough to do the job. The 100, 120, and 150 are the most frequently used.To tell you the truth, I rarely use the 320. The vacuum draw that leaks around the inlet, sucks up that last 1% of the dust coming off the paper. That is about 3 for each grade.
Over time, even that is a consideration. The advantage to quality paper, is that you can get in a groove with some consistency. Instead of having cheaper paper that gives you the new disc agressiveness, then quickly to the used paper smoothness, which may be a grade finer, and miss the deeper lines from the coarser grade of paper in the previous step. When I first bought my Bosch 3727DVS, I bought a box of the popular grades; 80, 100, 120, 150, 180, 220, and 320. I had a body shop for 20 years, and after using the cheaper paper on the random orbit sanders, and winding up with a floor full of used paper, I can attest to the savings of using quality, aluminum oxide paper. I simply attach a 2 1/2" vac hose to the dust port on my Bosch, which is way smaller than that, so a lot of air escapes.
It is still recommended to wear a mask because the shop vacs only capture to a micron or so. So technically you have a vac system that is actually a mini-part of a micron, invisible dust manufacturing plant.
It is actually cheaper, in addition to doing a better job. I just went through over 50 boards of 80+ inch cedar, in three grades, and I only used about 10 sheets all combined.
A good respirator, not a paper mask is advisable. That way you don't wind up with a buggered edge on your sander.
The 6 hole paper is nice for the dust free environment. A fresh air system is even better.
Highly recommended.
|
